escootersandparts logo

Why is my hoverboard Bluetooth not working?

Table of Contents

Why is my hoverboard Bluetooth not working? Make sure that both the hoverboard, and the device you are trying to connect to, have bluetooth turned on. The hoverboard will automatically turn the bluetooth on, but will turn off after two minutes of no connection. To connect a device after two minutes, turn the hoverboard off and then on again.

How do I know my hover 1 is charging? If the charger is functioning normally, a small light on the charger will turn green. If the board is not fully charged, plugging it in will cause the light to turn red. Once the hoverboard is fully charged, the charger light will turn green.

What does red flashing light mean on hover 1? Hoverboard Has Flashing Red Light. This means that internal circuitry of the motor is causing the wheel on the motherboard side to malfunction. This requires a full replacement of the motherboard side motor. Please view Hover-1 Liberty Gyroscope Sensor Boards Replacement.

Where is the reset button on electric scooter? The reset button (on the left side of the battery box) will automatically trip and turn off the power if the motor is overloaded. An excessive overload, steep incline or too heavy of a rider could have caused the motor to overheat and tripped the breaker.

Why is my hoverboard Bluetooth not working? – Related Questions

 

What does it mean if your hoverboard keeps beeping?

Your hoverboard will beep, too, tell you when the battery is low on juice. You’ll know if this is the case by also checking out the battery indicator light(s) on top of the board. Some of our models have a single battery indicator light.

How do I reset my hover 1?

What does an orange light mean on hover 1?

The flashing orange light is caused by a problem in the battery pack. This problem is usually related to a bad circuit board in the battery pack, also known as the battery management system or “BMS” PCB.

What do you do when your hoverboard stops working?

You can unscrew and remove the bottom of the hoverboard and inspect the charging port wires for faults and make sure it is plugged in properly. If the charging port is faulty or missing cables, you can purchase them here. If a new charing port does not fix your problem, then you would need one of our repair kits.

Is there a reset button on a hover board?

How long is the warranty on hover-1?

The Scooter Manufacture Hover-1 states the Scooter has a Limited 90-Day Warranty, which covers Battery, Motherboards, Lights, Bluetooth Module, and charger if issue is caused by Manufacture Defect. Accidental/Mistreated equipment is NOT covered.

Why is my hover 1 not working?

The Hoverboard Needs to Recalibrate. Sometimes if the system is not calibrated properly, the hoverboard will remain unstable. In order to recalibrate, put the hoverboard on a flat surface, then press and hold the power button down until the LED lights begin to flash. After 30 seconds, shut the hoverboard off.

Share this article :
Table of Contents
WRITTEN BY
Matthew Johnson
FOLLOW ON
FOLLOW & SUBSCRIBE